Subaru Crosstrek Owners Manual: Safety precautions
CAUTION
- People with delicate skin may
suffer slight burns even at low
temperatures if they use the seat
heater for a long period of time.
When using the heater, always be sure to warn the persons concerned.
- Do not put anything on the seat which insulates against heat, such as a blanket, cushion, or similar items. This may cause the seat heater to overheat.
- When the seat is warmed enough or before you leave the vehicle, be sure to turn off the seat heater.
NOTE
Use of the seat heater for a long period of time while the engine is not running can cause battery discharge.
Seat heater (if equipped)
The seat heater is equipped in the front
seats.
The seat heater operates when the ignition
switch is either in the "ACC" or "ON"
position. ...
Operation
HI - Rapid heating
LO - Normal heating
Off
Left-hand side
Right-hand side
To turn on the seat heater, push the "LO"
or "HI" position on the switch, as desired,
depending on the ...
Other materials:
Dtc p2138 throttle/pedal position sensor/switch "d"/"e" voltage correlation
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2138 THROTTLE/PEDAL POSITION SENSOR/SWITCH "D"/"E" VOLTAGE CORRELATIONDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving pe ...
Bulkhead wiring harness (in engine compartment) Location
WIRING SYSTEM > Bulkhead Wiring Harness (In Engine Compartment)LOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionB35BlackB-2 Mass air flow and intake air temperature sensorB62Light grayC-3 Front ABS wheel speed sensor RHB85Light grayB-5 Front wiper motorB104Light grayC-4 Pressure switch ...
Automatic engine shutdown
The remote engine start system will
automatically shut down or will not start
the engine under the following conditions.
The total run-time has exceeded 20
minutes.
Any door or the rear gate is opened.
The select lever is moved to any
position other than "P".
The engine hood is opene ...
