Subaru Crosstrek Owners Manual: Automatic engine shutdown
The remote engine start system will automatically shut down or will not start the engine under the following conditions.
- The total run-time has exceeded 20 minutes.
- Any door or the rear gate is opened.
- The select lever is moved to any position other than "P".
- The engine hood is opened.
- The push-button ignition switch is pressed.
- The brake pedal is depressed.
- The engine speed is 3,000 rpm or more.
The time until the engine automatically stops differs according to the setting.
To change the time until the engine automatically stops, contact your SUBARU dealer. However, local laws and regulations may prohibit changing this time.
When starting the engine
To start the engine with remote engine
start system, briefly press the lock button
twice within 2 seconds, then press and
hold the lock button for 3 seconds.
1. Press the lock button briefly. Th ...
Models without "keyless access with push-button start system"
Remote engine starter transceiver (fob)
Fob button
...
Other materials:
Basic diagnostic procedure Procedure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.CHECK WARNING LIGHT.Check whether the airbag warning light in the combination meter is lit.Does the airbag warning light illuminate? Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.Perform ...
Entering the vehicle while it is running via remote start (models without "keyless
access with push-button start system")
1. Unlock the Subaru Ascent using the remote keyless entry system.
NOTE
If the Subaru Ascent is unlocked manually with a physical key while the alarm
system is armed, the alarm will activate and the engine will stop. To deactivate
the alarm, perform one of the following actions.
Insert the ...
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation
of the skid suppression function and
during activation of the traction control
function.
NOTE
The light may remain illuminated for
a short period of time after the engine
has been started, especially in cold
weather. This does not indicate ...
