Subaru Crosstrek Owners Manual: Seat, seatbelt and SRS airbags
- Front seats
- Forward and backward adjustment
- Reclining the seatback
- Seat height adjustment (driver's seat)
- Head restraint adjustment
- Seat heater (if equipped)
- Rear seats
- Seatbelts
- Seatbelt safety tips
- Automatic Locking Retractor/Emergency Locking Retractor (ALR/ELR)
- Fastening the seatbelt
- Seatbelt maintenance
- Front seatbelt pretensioners
- Driver's seatbelt
- Front passenger's seatbelt
- System monitors
- System servicing
- Precautions against vehicle modification
- Child restraint systems
- Where to place a child restraint system
- Choosing a child restraint system
- Installing child restraint systems with ALR/ELR seatbelt
- Installing a booster seat
- Installation of child restraint systems by use of lower and tether anchorages (LATCH)
- Top tether anchorages
- SRS airbag (Supplemental Restraint System airbag)
Function settings
A SUBARU dealer can change the settings of the functions shown in the
following table to meet your personal requirements. Contact
the nearest SUBARU dealer for details. If your vehicle is equipped ...
Front seats
WARNING
Never adjust the seat while driving
to avoid loss of vehicle control
and personal injury.
Before adjusting the seat, make
sure the hands and feet of rear
seat passengers and carg ...
Other materials:
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessINSPECTION1. BACK-UP LIGHT SWITCH1. Turn the ignition switch to OFF.2. Disconnect the back light switch connector.3. Measure the resistance between the back-up light switch terminals.Gear shift positionTerminal No.Specified resistanc ...
Dtc u1120 lost communication with autostart stop control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1120 LOST COMMUNICATION WITH AUTOSTART STOP CONTROL MODULENOTE:The electric power steering CM identifies whether the Auto Start Stop function is provided or not using information from the combination meter. The ...
Enabling functions
When the procedure to disable the functions
is performed again, a chirp sound will
be heard, and the functions are enabled.
NOTE
The keyless access function will be
enabled only if you perform the procedure
in the same manner you disabled
the function (for example, when disabling
by o ...
