Subaru Crosstrek Owners Manual: Head restraint adjustment
WARNING
- Never drive the vehicle with the head restraints removed because they are designed to reduce the risk of serious neck injury in the event that the vehicle is struck from the rear. Also, never install the head restraints the opposite way round. Doing so will prevent the head restraints from functioning as intended. Therefore, when you remove the head restraints, you must reinstall all head restraints correctly to protect vehicle occupants.
- All occupants, including the driver, should not operate a vehicle or sit in a vehicle's seat until the head restraints are placed in their proper positions in order to minimize the risk of neck injury in the event of a crash.
Both the driver's seat and front passenger's seat are equipped with head restraints.
Both head restraints are adjustable in the following ways.
Seat height adjustment (driver's seat)
When the lever is pushed down, the seat
is lowered.
When the lever is pulled up, the seat
rises.
The height of the seat can be adjusted by
moving the seat adjustment lever up and
dow ...
Head restraint height adjustment
Head restraint
Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove ...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Cowl PanelREMOVAL1. Open the front hood.2. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">3. Remove the cowl panel - side.(1) Remove the clips.(2) Release the claws, and then remove the cowl panel - side.CAUTION:Pulling with excessive f ...
Daylight saving time setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
"
switch to
select the "Daylight Saving Time" item.
Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection ...
Electrical specification
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONCAUTION:Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.Terminal No.Terminal nameInput/Output valueNote1Airbag CM commun ...
