Subaru Crosstrek Owners Manual: Head restraint height adjustment
- Head restraint
- Release button
To raise: Pull the head restraint up.
To lower: Push the head restraint down while pressing the release button on the top of the seatback.
To remove: While pressing the release button, pull out the head restraint.
To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. Press and hold the release button to lower the head restraint.
Each head restraint should be adjusted so that the center of the head restraint is closest to the top of the occupant's ears.
NOTE
When the head restraint cannot be pulled out or installed due to insufficient clearance between the head restraint and the roof, tilt the seat and then perform the installation and removal tasks.
Head restraint adjustment
WARNING
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the
risk of serious neck injury in the
event that the vehicle is struck
from the rear ...
Head restraint angle adjustment
The angle of the head restraint can be
adjusted in several steps. While maintaining
a suitable driving posture, adjust the
head restraint to a position where the back
of your head is as close ...
Other materials:
Selecting audible signal operation (models without "keyless access with
push-button start system")
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Perform the following steps to deactivate
the audible signal. You can also use the
same steps to restore the function.
1. Sit in the drive ...
Dtc c0046 body integrated module communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0046 BODY INTEGRATED MODULE COMMUNICATION CIRCUITDTC detecting condition:No CAN signal received from body integrated unit.Trouble symptom:• VDC may not operate.• Hill start assis ...
Read diagnostic trouble code (dtc) Operation
LAN SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «All diagnosis code».NOTE:• For detail ...
