Subaru Crosstrek Owners Manual: System features
BSD/RCTA consists of the following functions.
- To detect a vehicle in a blind spot on an adjacent lane or a vehicle approaching at high speed while driving the vehicle (Blind Spot Detection)
- To detect a vehicle approaching from the right or left while reversing the vehicle (Rear Cross Traffic Alert)
The system uses radar sensors for the above functions.
NOTE
The BSD/RCTA radar sensor has been certified by the radio wave related laws of the U.S. When driving in other countries, certification of the country where the vehicle is driven must be obtained. For certification in the U.S., refer to "Certification for the BSD/ RCTA" F7-55.
BSD/RCTA (if equipped)
The BSD/RCTA consists of rear radar with
Blind Spot Detection and Rear Cross
Traffic Alert.
These functions enable the system to
detect objects or vehicles to the rear,
drawing attention to the ...
Blind Spot Detection (BSD)
Operating range
The system warns the driver of dangers as
follows.
If the system detects vehicles in the
driver's blind spots, the BSD/RCTA approach
indicator light(s) on the outsid ...
Other materials:
Removal
ENTERTAINMENT > Rear SpeakerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. Remove the rear speaker assembly.(1) Remove the screws.(2) Disconnect the connector behind the speaker and remove the rear speak ...
Location
VEHICLE DYNAMICS CONTROL (VDC) > Relay and FuseLOCATIONMain fuse boxFuse 50A (VDC CM&H/U)(A)Fuse 30A (VDC CM&H/U)(B)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit"> ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSTALLATION1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.• Apply NICHIMOLY N-130 or the equivale ...
