Subaru Crosstrek Owners Manual: BSD/RCTA (if equipped)
The BSD/RCTA consists of rear radar with Blind Spot Detection and Rear Cross Traffic Alert.
These functions enable the system to detect objects or vehicles to the rear, drawing attention to the driver when changing a lane or when driving in reverse.
WARNING
The driver is responsible for driving safely. Always be sure to check the surroundings with your eyes when changing lanes or reversing the vehicle.
The system is designed to assist the driver in changing lanes or reversing safely by monitoring the rear and side areas of the vehicle. However, you cannot rely on this system alone in assuring the safety during a lane change or reversing. Overconfidence in this system could result in an accident and lead to serious injury or death. Since the system operation has various limitations, the flashing or illumination of the BSD/RCTA approach indicator light may be delayed or it may not operate at all even when a vehicle is present in a neighboring lane or approaching from either side.
The driver is responsible for paying attention to the rear and side areas of the vehicle.
- System features
- System operation
- BSD/RCTA approach indicator light/warning buzzer
- BSD/RCTA warning indicator
- BSD/RCTA OFF switch
- Certification for the BSD/RCTA
- Handling of radar sensors
To decrease the speed (by brake pedal)
1. Depress the brake pedal to release
cruise control temporarily.
2. When the speed decreases to the
desired speed, press the "RES/SET"
switch to the "SET" side once. Now the
desired speed is ...
System features
BSD/RCTA consists of the following functions.
To detect a vehicle in a blind spot on an
adjacent lane or a vehicle approaching at
high speed while driving the vehicle (Blind
Spot Detection)
...
Other materials:
Inspection
LIGHTING SYSTEM > Ignition Switch IlluminationINSPECTIONSTEPCHECKYESNO1.CHECK THE IGNITION SWITCH ILLUMINATION.Make sure the ignition switch illumination illuminates when driver’s side door is open.Does the ignition switch illumination illuminate?Ignition switch illumination is normal. Igni ...
Installation
REAR SUSPENSION > Rear Shock AbsorberINSTALLATIONCAUTION:• Use a new flange nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.1. Install each part in the reverse order of removal.Tightening torque:Refer ...
Dtc u0122 lost communication with vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data from VDC CM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Pro ...
