Subaru Crosstrek Owners Manual: BSD/RCTA approach indicator light/warning buzzer
While the BSD/RCTA is active, the following item(s) will operate to alert the driver:
- The BSD/RCTA approach indicator light (when there are vehicles in the neighboring lanes).
- The BSD/RCTA approach indicator light and warning buzzer (when a vehicle is approaching from the left or right side while your vehicle is reversing)
- BSD/RCTA approach indicator light
- Safety tips regarding the BSD/RCTA approach indicator light/warning buzzer
System operation
Operating conditions
The BSD/RCTA will operate when all of
the following conditions are met.
The ignition switch is in the "ON"
position.
The BSD/RCTA warning indicator and
BSD/RCTA OFF in ...
BSD/RCTA approach indicator light
BSD/RCTA approach indicator light
It is mounted on each side of the outside
mirrors.
The indicator light will illuminate when a
vehicle approaching from behind is detected.
The indicator ...
Other materials:
Inspection mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Inspection ModeOPERATIONIt is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is r ...
Disassembly
CLUTCH SYSTEM > Master CylinderDISASSEMBLY1. Remove the straight pin and nipple.(A)Nipple(B)Straight pin2. Remove the oil seal.(A)Oil seal3. Move the seat towards the rear.(A)Seat(B)Master cylinder4. Remove the piston stop ring.CAUTION:When removing the piston stop ring, be careful to prevent the ...
Dtc p0506 idle control system rpm - lower than expected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0506 IDLE CONTROL SYSTEM RPM - LOWER THAN EXPECTEDDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start the engine.• Engine does not ...
