Subaru Crosstrek Owners Manual: To decrease the speed (by brake pedal)
1. Depress the brake pedal to release cruise control temporarily.
2. When the speed decreases to the desired speed, press the "RES/SET" switch to the "SET" side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.
Cruise control indicator light
Refer to "Cruise control indicator light" F3-31.
Cruise control set indicator light
Refer to "Cruise control set indicator light" F3-31.
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated a ...
BSD/RCTA (if equipped)
The BSD/RCTA consists of rear radar with
Blind Spot Detection and Rear Cross
Traffic Alert.
These functions enable the system to
detect objects or vehicles to the rear,
drawing attention to the ...
Other materials:
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle BodyREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL">4. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. Engine Coolant > REPLACEMENT"& ...
Installing child restraint systems with ALR/ELR seatbelt
WARNING
Child restraint systems and seatbelts
can become hot in a vehicle
that has been closed up in sunny
weather; they could burn a small
child. Check the child restraint
system before you place a child
in it.
Do not leave an unsecured child
restraint system in your vehicle.
...
Dtc p0616 starter relay "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0616 STARTER RELAY "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATI ...
