Subaru Crosstrek Owners Manual: Cruise control (if equipped)
NOTE
For models with EyeSight system: Refer to the Owner's Manual supplement for the EyeSight system.
Cruise control enables you to maintain a constant vehicle speed without holding your foot on the accelerator pedal and it is operative when the vehicle speed is 25 mph (40 km/h) or more.
WARNING
Do not use the cruise control under any of the following conditions.
These may cause loss of vehicle control.
- driving up or down a steep grade
- driving on slippery or winding roads
- driving in heavy traffic
- towing a trailer
NOTE
Make sure the cruise control system is turned off when the cruise control is not in use to avoid unintentionally setting of the cruise control.
Hill start assist system
WARNING
The Hill start assist system is a
device only for helping the driver
to START the vehicle on an uphill
grade. To prevent accidents
when the vehicle is parked on a
slope, be sure ...
To set cruise control
Cruise control main button
1. Press the cruise control main button.
Cruise control indicator light (type A)
Cruise control indicator light (type B)
The cruise control indicator light o ...
Other materials:
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Drive GearINSTALLATION1. Install the reduction drive gear to secondary pulley.2. Select the reduction drive gear shim. Reduction Drive Gear > ADJUSTMENT">3. Install the dish plates, spring retainers, and selected reduction drive ge ...
Dtc p0366 camshaft position sensor "b" circuit range/performance bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0366 CAMSHAFT POSITION SENSOR "B" CIRCUIT RANGE/PERFORMANCE BANK 1NOTE:For the diagnostic procedure, refer to DTC P0365. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0365 CAMSH ...
Removal
CLUTCH SYSTEM > Clutch SwitchREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Turn the ignition switch to OFF.2. Disconnect the ground cabl ...
