Subaru Crosstrek Service Manual: Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor
INSTALLATION
CAUTION:
• Replace the O-rings on the hose - pressure suction and discharge with new parts, and then apply compressor oil.
• After replacing the compressor assembly, adjust the amount of the compressor oil. Compressor Oil > ADJUSTMENT">
1. Install each part in the reverse order of removal.
Tightening torque:
Air conditioning unit: General Description > COMPONENT">
Compressor: General Description > COMPONENT">
V-belt cover bracket and generator bracket: General Description > COMPONENT">
2. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorREMOVAL1. CROSSTREK MODEL1. Perform compressor oil return operation. Compressor Oil > PROCEDURE">2. Turn the A/C switch to OFF, and ...
Compressor oil
...
Other materials:
Dtc u0101 lost communication with tcm
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDTC detecting condition:No data is received from TCM.Trouble symptom:Cooperation control with transmission is not performed.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC P ...
Disassembly
EXTERIOR/INTERIOR TRIM > Door TrimDISASSEMBLY1. Remove the door trim.2. Remove the rivets and claws, and remove the weather strip - door INN from the door trim.(a)Rivet(b)Claw(c)ClawNOTE:Remove the rivets by using the rivet cutter or nippers. ...
Disassembly
REAR SUSPENSION > Rear Trailing LinkDISASSEMBLY1. BUSHING A - TRAILING LINKUsing the ST, push out the bushing A - trailing link.Preparation tool:ST-A: INSTALLER (899874100)ST-B: INSTALLER & REMOVER (BASE) (20099PA010)2. BUSHING - TRAILING LINKFor the removal procedure of bushing - trailing li ...
