Subaru Crosstrek Service Manual: Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Subaru Rear Vehicle Detection(RH)» or «Subaru Rear Vehicle Detection(LH)» and then select «Enter».

5. On «Select Function» display, select «Active Test».

NOTE:

For detailed operation procedures, refer to “Application help”.

List

Basic diagnostic procedure Procedure

Other materials:

Before starting out on a trip
Check the towing regulations for trailer or caravan vehicles that vary by state/ region. Failure to comply with the procedures set forth will not only compromise your safety, but will also negate your insurance coverage and/or may violate the state road and traffic acts and regulation ...

List
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Read Current DataLISTDisplayContents to be displayedUnit of measureTire 1 FN codeLEARN, LOW BAT, OFF, WAKE, RE ME, NORMALLEARN: Transmitted transmitter ID using the transmitter registration toolLOW BAT: Transmitter battery voltage running lowOFF: Tr ...

Electrical specification
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. RADAR SENSORTerminal No.ContentMeasuring conditionStandardRadar sensor LH (master)Radar sensor RH (slave)1 ←> Chassis groundPrivate CAN HPrivate CAN HAlways1 M? or more2 &larr ...