ENTERTAINMENT > Data Communication Module
INSPECTION
1. BACKUP BATTERY
1. Measure the voltage between connector terminals.
Preparation tool:
Circuit tester

Terminal No. | Standard |
1 (+) — 2 (−) | 2 V or more |
2. Replace the backup battery if the inspection result is not within the standard value.
RemovalRemoval
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Wiring HarnessREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Remove the intake manifold. Intake Manifold > REMOVAL">4. Disconnect the connector from the engine.• Struc ...
Operation
HI - Rapid heating
LO - Normal heating
Off
Left-hand side
Right-hand side
To turn on the seat heater, push the "LO"
or "HI" position on the switch, as desired,
depending on the temperature.
Selecting the "HI" position will cause the
seat to heat up quicker.
To turn off ...
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorREMOVAL1. 5 DOOR MODEL1. Disconnect the ground cable from battery.2. Lift up the vehicle, and then remove the rear wheels.3. Remove the rear ABS wheel speed sensor.CAUTION:• Be careful not to damage the sensor.• Do not apply ...