Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed Sensor
INSPECTION
1. Set the ST between the TCM and bulkhead harness.
| ST 18460AA040 | CHECK BOARD |
2. Set the probe of oscilloscope to the check board connector.
Connector & terminal
No. 14 (+) — No. 42 (−):
(A) | + probe |
(B) | − probe |
3. Start and warm up the engine.
4. Lift up the vehicle.
CAUTION:
Lift up the vehicle until the tire bottom is 0.3 m (0.98 ft) or more above the ground.
5. Shift the select lever to “D” range.
6. Check the waveform of primary speed sensor with engine idling running.
NOTE:
The waveform cycle changes as the speed changes.
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, re ...
Other materials:
Average vehicle speed
U.S.-spec. models
Except U.S.-spec. models
This display shows the average vehicle
speed since the trip meter was last reset.
Trip knob
Pressing the trip knob toggles the display
between the average vehicle speed corresponding
to the A trip meter display and
the average veh ...
Dtc p0073 ambient air temperature sensor circuit "a" high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0073 AMBIENT AIR TEMPERATURE SENSOR CIRCUIT "A" HIGHNOTE:For the diagnostic procedure, refer to DTC P0072. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0072 AMBIENT AIR TEMPERA ...
Dtc c2323 transmitter 3 function code abnormal
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2323 TRANSMITTER 3 FUNCTION CODE ABNORMALNOTE:Refer to DTC C2324 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2324 TRANSMITTER 4 FUNCTION COD ...
