Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Preparation for maintenance settings

1. Turn the ignition switch to the "ON" position.

2. Push and hold the  button to show the selection screen.

Preparation for maintenance settings

3. After the selection screen is displayed, operate the "  " or " " switch to show the "Maintenance" item. Then, push the button.

Maintenance settings
The items in the maintenance settings can be set. To change the items, operate the "  " or "  " switch. ...

Engine oil setting
1. Perform the preparation steps according to "Preparation for maintenance settings" 2. Operate the "  " or "  " switch to select the "Engine Oil" item. Then push the  but ...

Other materials:

Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...

Inspection
LIGHTING SYSTEM > SRF OFF SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3OFF1 M? or moreONLess than 1 ?2. Apply battery voltage between the connector terminals to check lighting condition of illu ...

Dtc c1532 bls on stuck
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1532 BLS ON STUCKDTC detecting condition:Defective stop light switchTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.WIRIN ...

© 2016-2022 Copyright www.sucross.com