Subaru Crosstrek Service Manual: Component
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General Description
COMPONENT
1. CANISTER, LEAK CHECK VALVE ASSEMBLY AND DRAIN SEPARATOR
For structures of the canister, leak check valve assembly and drain separator, refer to “FU (H4DO)”. General Description > COMPONENT">
2. EGR SYSTEM 1
(1) | EGR control valve | (7) | O-ring | Tightening torque: N·m (kgf-m, ft-lb) | |
(2) | O-ring | (8) | Clip | T1: | 6.4 (0.7, 4.7) |
(3) | Gasket | (9) | Preheater hose A | T2: | 18 (1.8, 13.3) |
(4) | Engine coolant temperature sensor | (10) | Clip | T3: | 22 (2.2, 16.2) |
(5) | Gasket | (11) | Preheater hose B | ||
(6) | Water pipe ASSY (MT model) | (12) | Water pipe ASSY (CVT model) | ||
3. EGR SYSTEM 2
(1) | Gasket | (6) | Gasket | Tightening torque: N·m (kgf-m, ft-lb) | |
(2) | Gasket | (7) | Gasket | T1: | EGR Pipe > INSTALLATION"> |
(3) | EGR pipe | (8) | Clip | T2: | EGR Cooler > INSTALLATION"> |
(4) | EGR cooler (CVT model) | (9) | Engine coolant hose | ||
(5) | EGR cooler (MT model) | ||||
4. PCV SYSTEM 1
(1) | PCV connector | (3) | O-ring | Tightening torque: N·m (kgf-m, ft-lb) | |
(2) | O-ring | T: | 6.4 (0.7, 4.7) | ||
5. PCV SYSTEM 2
(1) | PCV hose A | (3) | PCV hose B | Tightening torque: N·m (kgf-m, ft-lb) | |
(2) | PCV valve | (4) | Clip | T: | 23 (2.3, 17.0) |
Preparation tool
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General DescriptionPREPARATION TOOL1. GENERAL TOOLTOOL NAMEREMARKSCircuit testerUsed for measuring resistance, voltage and current. ...
Other materials:
Electrical component location Location
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Electrical Component LocationLOCATION1. CONTROL MODULE(1)Transmission control module (TCM)(3)AWD light(5)Body integrated unit(2)AT OIL TEMP light(4)Engine control module (ECM)(6)Data link connector2. SENSOR(1)Secondary speed sensor(3)Primary spee ...
Dtc b1409 scu communication
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1409 SCU COMMUNICATIONDTC detecting condition:Communication failure between body integrated unit and security control moduleCAUTION:When the body integrated unit is replaced, registration of the immobilizer sy ...
Removal
LIGHTING SYSTEM > Rear Side Marker Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...
