Subaru Crosstrek Service Manual: Operation

1. RESET OPERATION A

1. Sit in the driver’s seat and close the door.

2. Turn the ignition switch to ON.

3. Operate the switch - power window main to open the glass assembly - front door halfway.

4. Operate the switch - power window main in “UP” direction to fully close the glass assembly - front door on the driver’s side.

5. While the glass assembly - front door is fully closed, hold down the switch - power window main in “UP” direction for one second.

6. Operate the switch - power window main in “AUTO DOWN” direction to check whether the window fully opens properly.

NOTE:

If the window does not fully open properly, repeat steps 1) to 6).

1. Sit in the driver’s seat and close the door.

2. Turn the ignition switch to ON.

3. On the glass assembly - front door of the driver’s side, operate the “AUTO UP” function (fully pull up the switch) using the switch - power window main, and perform auto-reverse operations 10 times in a row (after the window fully closes, it slightly opens).

4. Check that the “AUTO UP” function no longer operates.

5. Perform reset operation A.

6. Check that the window operates properly by operating the “AUTO UP” and “AUTO DOWN” switch.

NOTE:

If the window does not fully open/close properly, repeat steps 1) to 6).

Note

Rear door glass

Other materials:

Dtc b2785 lin communication
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2785 LIN COMMUNICATIONDTC detecting condition:When the keyless access CM detected the collation system LIN bus communication error three times in a row.Trouble symptom:The keyl ...

Models without multi function display
NOTE For models with information display (black and white), refer to "Information display" The U.S.-spec models are not equipped with the multi function display. The other models may be equipped with the multi function display or not, depending on the model. Safety precautions WARNING Alw ...

Dtc c0046 body integrated module communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0046 BODY INTEGRATED MODULE COMMUNICATION CIRCUITDTC detecting condition:No CAN signal received from body integrated unit.Trouble symptom:• VDC may not operate.• Hill start assis ...