Removal
INSTRUMENTATION/DRIVER INFO > Combination MeterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.3. Release the screws, clips and claws, and remove the visor - com ...
Installation
LUBRICATION(H4DO) > Oil Level SwitchINSTALLATION1. Install the oil level switch and the clip (A) to the oil pan upper.NOTE:• Use new O-rings.• Apply a coat of engine oil to the O-rings.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the engine mounting LH onto the en ...
Switches and harness
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Switches and HarnessINSPECTIONBSD/RCTA OFF switch1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply ba ...