Subaru Crosstrek Service Manual: Inspection
GLASS/WINDOWS/MIRRORS > Power Window System
INSPECTION
Symptoms | Inspection order |
All power windows do not operate. |
(1) Check the fuse.
(2) Check the power window relay.
(3) Check the wiring harness.
Particular window does not operate.
(1) Check the fuse.
(2) Check the switch - power window main.
(3) Check the switch - power window sub.
(4) Check the power window motor.
(5) Check the wiring harness.
“Window Lock” does not operate.
Check the switch - power window main.
Driver’s side window moves slightly (approx. 20 mm (0.79 in)).
(1) Check the motor - front.
(2) Check the switch - power window main.
(3) Check the wiring harness.
Driver’s side window moves slightly (approx. 50 mm (1.97 in)). (This status is not a failure.)
Perform reset operation A. Power Window System > OPERATION">
Driver’s side window does not close completely. (Using AUTO UP allows the window to fully close first and then move in reverse resulting in slightly opening.)
Perform reset operation B. Power Window System > OPERATION">
Wiring diagram
GLASS/WINDOWS/MIRRORS > Power Window SystemWIRING DIAGRAMRefer to “Power Window System” in the wiring diagram. Power Window System > WIRING DIAGRAM"> ...
Other materials:
Inspection
REAR SUSPENSION > Rear Shock AbsorberINSPECTION1. Check for oil leaks.2. Move the piston rod up and down to check that it operates smoothly without any hitch.3. Check the piston rod for play as follows:(1) Fix the outer shell in place and fully extend the rod.(2) Set the dial gauge on the end of ...
To increase the speed (by the "RES/ SET" switch)
Press the "RES/SET" switch to the "RES"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...
Beep volume setting
1. Perform the preparation steps according
to "Preparation for image quality and
volume settings"
2. Operate the "
" or "
" switch to
select the "Beep" item. Then push the
button.
3. Push the
button.
4. Select an item by operating the " " or
" " switch. Then pus ...
