Subaru Crosstrek Service Manual: Throttle position sensor Specification
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle Position Sensor
SPECIFICATION
Throttle body is a non-disassembled part, so do not remove the throttle position sensor from throttle body.
Refer to “Throttle Body” for removal and installation procedure. Throttle Body > REMOVAL">
Throttle Body > INSTALLATION">
Fuel system trouble in general Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel System Trouble in GeneralINSPECTIONTroublePossible causeCorrective actionInsufficient fuel supply to fuel injectora. Fuel pump does not operate. Defec ...
Other materials:
Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Stopper
2. Remove the wiper blade assembly by
holding its pivot area and pushing it in the
direction shown by the arrow while depressing
the wiper blade stopper.
3. Install the wiper blade assembly to the
wiper arm. Make sure that it locks i ...
Installation
ENTERTAINMENT > AntennaINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer to “CAUTION” of ...
Inspection
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSPECTIONCheck the removed parts for damage, wear, corrosion etc. Repair or replace if defective.• DOJ (Double Offset Joint):Check for seizure, corrosion, damage, wear and excessive play.• BJ (Bell Joint):Check for seizure, corrosion, damage and e ...
