Subaru Crosstrek Service Manual: Inspection
DRIVE SHAFT SYSTEM > Rear Drive Shaft
INSPECTION
Check the removed parts for damage, wear, corrosion etc. Repair or replace if defective.
• DOJ (Double Offset Joint):
Check for seizure, corrosion, damage, wear and excessive play.
• BJ (Bell Joint):
Check for seizure, corrosion, damage and excessive play.
• EBJ (High-Efficiency Compact Ball Fixed Joint):
Check for seizure, corrosion, damage and excessive play.
• Shaft:
Check for excessive bending, twisting, damage and wear.
• Boot:
Check for wear, warping, breakage and scratches.
• Grease:
Check for discoloration and fluidity.
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen t ...
Installation
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSTALLATION1. Replace the rear differential side oil seal. Rear Differential Side Oil Seal > REPLACEMENT">NOTE:After pulling out the drive shaft as ...
Other materials:
Real-time diagnosis Operation
EyeSight (DIAGNOSTICS) > Real-time DiagnosisOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select «EyeSi ...
Installation
EXTERIOR BODY PANELS > Front FenderINSTALLATION1. Install each part in the reverse order of removal.CAUTION:• Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumpe ...
Removal
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the latch and actuator - rear gate.(1) Disconnect the connector.(2) Remove the bolts, ...
