Subaru Crosstrek Owners Manual: Rear windows side seating position
- Head restraint
- Release button
To remove: While pressing the release button, pull out the head restraint.
To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. Press and hold the release button to lower the head restraint.
After installing the head restraint, make sure it is securely locked.
Head restraint adjustment
Both the rear window side seats and the
rear center seat are equipped with head
restraints.
WARNING
Never drive the vehicle with the
head restraints removed because
they are designed to red ...
Rear center seating position
CAUTION
The head restraint is not intended to
be used at the retracted position.
Before sitting on the seat, raise the
head restraint to the extended position.
Incorrect (retracted posit ...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Floor MatREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is lo ...
Dtc c0071 no signal from steering angle sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0071 NO SIGNAL FROM STEERING ANGLE SENSORDTC detecting condition:Communication from steering angle sensor is faulty.Trouble symptom:• VDC does not operate.• EyeSight does not ope ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the glove box. Glove Box > REMOVAL">3. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">4 ...
