Subaru Crosstrek Service Manual: Diagnostics with phenomenon Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostics with Phenomenon
INSPECTION
Symptoms | Maintenance parts |
BSD/RCTA does not operate. | Fuse |
LAN system Basic Diagnostic Procedure"> | |
Body control system Basic Diagnostic Procedure"> | |
Radar sensor LH | |
Radar sensor RH | |
BSD/RCTA cannot be turned OFF. | BSD/RCTA OFF switch |
LAN system Basic Diagnostic Procedure"> | |
Body control system Basic Diagnostic Procedure"> | |
Radar sensor LH | |
Error message appears in the combination meter. | CHECK CANCEL CODE. Read Cancel Code"> |
Radar sensor LH | |
Radar sensor RH | |
Combination meter Basic Diagnostic Procedure"> | |
Outer mirror assembly (LH) indicator does not illuminate. | Outer mirror assembly Outer Mirror Assembly"> |
Radar sensor LH | |
Outer mirror assembly (RH) indicator does not illuminate. | Outer mirror assembly Outer Mirror Assembly"> |
Radar sensor RH | |
Outer mirror assembly (LH) indicator remains on. | Radar sensor LH |
Outer mirror assembly (RH) indicator remains on. | Radar sensor RH |
Outer mirror assembly (LH) indicator does not blink. | Radar sensor LH |
Outer mirror assembly (RH) indicator does not blink. | Radar sensor RH |
Outer mirror assembly (LH) indicator keeps blinking. | Radar sensor LH |
Outer mirror assembly (RH) indicator keeps blinking. | Radar sensor RH |
Diagnostic procedure with cancel code Dtc b2328 rear radar internal failure (radar misalignment)
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Cancel CodeDTC B2328 REAR RADAR INTERNAL FAILURE (RADAR MISALIGNMENT)DETECTING CONDITION:• Excessive im ...
Electrical component location Location
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Outer mirror assembly RH(3)Radar sensor RH (slave)(5)BSD/RCTA OFF switch(2)Outer mirror assembl ...
Other materials:
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorINSPECTION1. Check that the fuel sub level sensor has no damage.2. Measure the fuel sub level sensor float position.(1)FULL(2)EMPTY(3)Datum pointsFloat positionStandardFULL to Datum point (A)5.31±3.5 mm (0.209±0.138 in)EMPTY to Datum po ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Air Breather HoseREMOVAL1. FRONT DIFFERENTIAL SIDE1. Remove the clip (A) from the air intake boot.2. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).3. Loosen the clamp (C) which connects the air intake boot and throttle ...
Note
EyeSight > EyeSight SystemNOTEFor procedure of each component in the EyeSight system, refer to the respective section.• Control module: Control Unit">NOTE:System control of the EyeSight is performed by each module. For procedure, refer to the following sections.– Engine control ...
