Subaru Crosstrek Service Manual: Electrical component location Location
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Electrical Component Location
LOCATION
(1) | Outer mirror assembly RH | (3) | Radar sensor RH (slave) | (5) | BSD/RCTA OFF switch |
(2) | Outer mirror assembly LH | (4) | Radar sensor LH (master) | (6) | Data link connector |
Diagnostics with phenomenon Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostics with PhenomenonINSPECTIONSymptomsMaintenance partsBSD/RCTA does not operate.FuseLAN system Basic Diagnostic Procedure" ...
Inspection mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Inspection ModeOPERATIONIt is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perfo ...
Other materials:
Installation
EXTERIOR/INTERIOR TRIM > Rear BumperINSTALLATIONInstall each part in the reverse order of removal.CAUTION:Before installing the bumper face, match the claws on the bracket - rear bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, ...
Installation
BRAKE > Rear Disc RotorINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly.1. Before installation, check the rear disc rotor. Rear Disc Rotor > INSPECTION">2. Install each part in the reverse order of removal.NOTE:When installing the rear ...
Basic operation
Control switches
By using
or
on the steering wheel controls, the driver of the Subaru Ascent can seamlessly switch
between different display screens and information panels.
When important notifications arise, such as vehicle status updates or safety
w ...
