Subaru Crosstrek Service Manual: Installation
EXTERIOR/INTERIOR TRIM > Rear Bumper
INSTALLATION
Install each part in the reverse order of removal.
CAUTION:
Before installing the bumper face, match the claws on the bracket - rear bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform.
NOTE:
If the bumper face - rear comes off too easily, adjust the hook of the bracket side.
Tightening torque:
Rear bumper component: General Description > COMPONENT">
Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Rear bumper
...
Repair
EXTERIOR/INTERIOR TRIM > Rear BumperREPAIRRefer to the description concerning repair in “Front Bumper” section. Front Bumper > REPAIR"> ...
Other materials:
Dtc u1433 invalid data received from eyesight
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1433 INVALID DATA RECEIVED FROM EyeSightDTC DETECTING CONDITION:Defective data was transmitted from stereo camera.TROUBLE SYMPTOM:Cooperation control of EyeSight does not operate properly.STEPCHECKYESNO1.CHECK ...
Vehicle load limit - how to determine
The load capacity of your vehicle is
determined by weight, not by available
cargo space. The load limit of
your vehicle is shown on the
vehicle placard attached to the
driver's side door pillar. Locate the
statement "The combined weight of
occupants and cargo should never
exceed XXX kg or XX ...
Electrical component location Location
IMMOBILIZER (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Security indicator light (LED bulb)(3)Data link connector(5)Transponder(2)Body integrated unit(4)Antenna(6)Security control module (for C5 model only) ...
