Subaru Crosstrek Owners Manual: Rear center seating position
CAUTION
The head restraint is not intended to be used at the retracted position.
Before sitting on the seat, raise the head restraint to the extended position.
- Incorrect (retracted position)
- Correct (extended position)
To raise: Pull the head restraint up.
To lower: Push the head restraint down while pressing the release button on the top of the seatback.
To remove: While pressing the release button, pull out the head restraint.
To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. Press and hold the release button to lower the head restraint.
When the rear-center seating position is occupied, raise the head restraint to the extended position. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility.
Rear windows side seating position
Head restraint
Release button
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on th ...
Folding down the rear seatback
WARNING
When you fold down the seatback,
check that there are no
passengers or objects on the
rear seat. Not doing so creates
a risk of injury or property damage
if the seatback suddenly ...
Other materials:
Refrigerant leak check Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Leak CheckINSPECTION1. Attach the manifold gauge set.Preparation tool:Manifold gauge set(1) Check that all valves are fully closed.(2) Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle resp ...
Removal
COOLING(H4DO) > Radiator Main Fan and Fan MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the reservoir tank. Reservoir Tank > REMOVAL">3. Disconnect the connector from the main fan motor assembly.4. Remove the bolts which hold the radiator main fan s ...
Precautions against vehicle modification
WARNING
To avoid accidental activation of the
system or rendering the system
inoperative, which may result in
serious injury, no modifications
should be made to any components
or wiring of the SRS airbag system.
This includes following modifications.
Installation of custom steering
wh ...
