WARNING

Lock release knob
WARNING
When you return the seatback to its original position, check that the unlocking marker on the lock release knob is not visible. Also, shake the seatback slightly to confirm that it is securely fixed in place.
If the seatback is not securely fixed in place, the seatback may suddenly fold down in the event of sudden braking, or objects may move out from the cargo area, which could cause serious injury or death.

WARNING
When the seatback is returned to its original position, observe the following precautions. Failure to do so may lead to serious injury or an accident because the operation efficiency of the seatbelt is inhibited.

Unlock the seatback by pulling the lock release knob and then fold the seatback down.
To return the seatback to its original position, raise the seatback until it locks into place and make sure that the unlocking marker on the lock release knob is no longer visible.
Rear center seating position
SeatbeltsOperating tips for heater and air conditioner
Cleaning ventilation grille
Front ventilation inlet grille
To maintain optimal performance of the Subaru Ascent climate system, always keep
the ventilation inlet grille free from snow, debris, leaves, or dirt. Blockages
can reduce heating efficiency and impair defrosting capability.
...
General scan tool Operation
ENGINE (DIAGNOSTICS)(H4DO) > General Scan ToolOPERATION1. HOW TO USE GENERAL SCAN TOOL1. Prepare a scan tool (general scan tool) required by SAE J1978.2. Connect the general scan tool to data link connector located in the lower portion of the instrument panel (on the driver’s side).3. Using ...
Dtc u0140 lost communication with body control module
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULEDetected when CAN data is not received from body integrated unit.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE" ...