Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Fuel system trouble in general Inspection

Subaru Crosstrek Service Manual / Fuel injection (fuel systems)(h4do) / Fuel system trouble in general Inspection

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel System Trouble in General

INSPECTION

Trouble

Possible cause

Corrective action

Insufficient fuel supply to fuel injector

a. Fuel pump does not operate.

Defective terminal contact

Inspect contact, especially ground, and tighten it securely.

Trouble in electromagnetic or electronic circuit parts

Replace the faulty parts.

b. Decline of fuel pump function

Replace the fuel pump.

c. Clogged fuel filter

Replace the fuel filter. Clean or replace the fuel tank if necessary.

d. Clogged or bent fuel line pipe, hose or tube

Clean, correct or replace the fuel line pipe, hose or tube.

e. Air is mixed in fuel system.

Check the fuel line connections, correct or replace the defective part.

f. Damaged diaphragm of pressure regulator

Replace the fuel filter assembly.

Leakage or blow out of fuel

a. Loose connections of fuel line pipe, hose or tube

Check the fuel line connections, correct or replace the defective part.

b. Cracked fuel line pipe, hose or tube

Replace the fuel line pipe, hose or tube.

c. Cracked fuel tank or defective welding part

Replace the fuel tank.

d. Clogged or bent fuel line pipe, hose or tube

Clean, correct or replace the fuel line pipe, hose or tube.

Gasoline smell inside of compartment

a. Loose connections of fuel line pipe, hose or tube

Check the fuel line connections, correct or replace the defective part.

b. Defective gasket of fuel saucer or fuel filler pipe assembly

Correct or replace the gasket.

c. Defective canister

Replace the canister.

Defective fuel gauge

a. Defective operation of fuel level sensor

Replace the fuel level sensor.

b. Defective operation of combination meter Basic Diagnostic Procedure > PROCEDURE">

Replace the combination meter.

Noise

a. Large operation noise or vibration of fuel pump

Replace the fuel pump.

NOTE:

When the vehicle is left unattended for an extended period of time, water may accumulate in the fuel tank. Fill fuel fully to prevent the problem.

In snow-covered areas, mountainous areas, skiing areas, etc. where ambient temperatures drop to 0°C (32°F) or less throughout the winter season, use a water removing agent in the fuel system to prevent freezing fuel system and accumulating water.

When water is accumulated in fuel filter, fill the water removing agent in the fuel tank.

Before using water removing agent, follow the cautions noted on the bottle.

Fuel Procedure
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > FuelPROCEDURE1. RELEASING OF FUEL PRESSUREWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:Be careful not to spill fuel.1. Remove ...

Throttle position sensor Specification
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle Position SensorSPECIFICATIONThrottle body is a non-disassembled part, so do not remove the throttle position sensor from throttle body.Refer to &ldquo ...

Other materials:

Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the re ...

Installation
AIRBAG SYSTEM > Side Airbag SensorINSTALLATIONCAUTION:Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.1. Before installation, inspect the following items and replace any faulty part with a new part.• The side airbag sensor, sensor bracket, or connector are ...

Adjustment
CLUTCH SYSTEM > Clutch PedalADJUSTMENT1. Turn the lock nut until the full stroke of clutch pedal becomes within the specification.CAUTION:When adjusting the full stroke of clutch pedal, do not turn the clutch switch.NOTE:If the lock nut cannot adjust the full stroke of clutch pedal to the specifi ...

© 2016-2026 Copyright www.sucross.com