Subaru Crosstrek Service Manual: Installation
GLASS/WINDOWS/MIRRORS > Power Window Control Switch
INSTALLATION
CAUTION:
• After installing the switch - power window main, always perform the initial setting.
Failure to do so may cause the improper activation of auto-reverse operation for pinching hazard prevention.
• Use protective paper to avoid damage to the trim panel.
1. Install each part in the reverse order of removal.
2. Perform initial setting operation (reset operation A). Power Window System > OPERATION">
Removal
GLASS/WINDOWS/MIRRORS > Power Window Control SwitchREMOVAL1. MAIN SWITCH1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove t ...
Other materials:
Installation
EXTERIOR BODY PANELS > Rear DoorINSTALLATION1. REAR DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - rear door on it.2. Apply grease to the moving part of door hinges.3. Adjust the height by the jack, and temporarily install the panel assembly - rear door to the upper hing ...
Caution
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > General DescriptionCAUTION1. SRS AIRBAG SYSTEMThe airbag system wiring harness is routed near the power steering control module.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses or connector circui ...
Basic diagnostic procedure Procedure
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURENOTE:When the sunload sensor check is performed indoors or in the shade, it could be diagnosed as sensor having an open circuit. Always perform the inspection in direct sunlight.STEPCHECKYESNO1.START INSPECTIONS.1) Prepare ...
