Subaru Crosstrek Service Manual: Removal
GLASS/WINDOWS/MIRRORS > Front Regulator and Motor Assembly
REMOVAL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - front door. Door Trim > REMOVAL">
3. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL">
4. Remove the glass assembly - front door. Front Door Glass > REMOVAL">
5. Remove the regulator and motor assembly - front.
(1) Disconnect the motor - front connector.
(2) Remove the bolts, and then remove the regulator and motor assembly - front.
Inspection
GLASS/WINDOWS/MIRRORS > Front Regulator and Motor AssemblyINSPECTION1. Disconnect the connector of the motor - front.2. Check the motor operation when battery voltage is applied between terminals o ...
Installation
GLASS/WINDOWS/MIRRORS > Front Regulator and Motor AssemblyINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Refer to “COMPONENT” of “General Descript ...
Other materials:
Disassembly
EXHAUST(H4DO) > Front Exhaust PipeDISASSEMBLY1. Remove the front oxygen (A/F) sensor and rear oxygen sensor from front exhaust pipe. Front Oxygen (A/F) Sensor > REMOVAL"> Rear Oxygen Sensor > REMOVAL">2. Remove the center exhaust pipe from the front exhaust pipe.3. Remove ...
Dtc p0024 "b" camshaft position - timing over-advanced or system performance bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0024 "B" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine sta ...
Clear memory mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Sele ...
