Subaru Crosstrek Service Manual: Installation

CAUTION:

• If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.

• When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring.

• When removing or replacing the seat cover, perform “Occupant Detection System Inspection” after installing the seat to check if the occupant detection system operates normally. PRE-DELIVERY INSPECTION (PDI) PROCEDURE">

• If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part.

• If the seat heater module is reused, remove the polyurethane section from the reverse side completely.

Double-sided tape for seat heater module adhesion:

NITTO DENKO’s 501L or equivalent

Removal

Security and locks

Other materials:

Dtc u0427 invalid data received from vehicle security control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0427 INVALID DATA RECEIVED FROM VEHICLE SECURITY CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from keyless access CM.TROUBLE SYMPTOM:Cooperation control of keyless access does not operat ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyINSTALLATION1. Install the front differential assembly to the converter case.NOTE:Be careful not to damage the inside of the case (especially the mounting surface of the differential side retainers).2. Install the bearing oute ...

Maximum load limits
WARNING Never exceed any of the specified load limits for the Subaru Ascent described in this section. Operating the Subaru Ascent beyond its maximum load capacity may lead to serious personal injury, compromised vehicle stability, and significant mechanical damage. CAUTION When the com ...