Subaru Crosstrek Service Manual: Removal

1. Disconnect the ground cable from battery. NOTE">

2. Remove the trim panel - rear pillar UPR. Rear Quarter Trim > REMOVAL">

3. Remove the glass - rear quarter in the same procedure as for the glass - front window. Windshield Glass > REMOVAL">

Installation

Rear regulator and motor assembly

Other materials:

Removal
LIGHTING SYSTEM > Back-up Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...

Electrical specification
LAN SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Body integrated unitFor I/O signals of the body integrated unit, refer to BODY CONTROL SYSTEM (DIAGNOSTICS). Control Module I/O Signal">• Engine CMFor I/O signals of ECM, refer to ENGINE (DIAGNOSTIC ...

Electrical component location Location
ENGINE (DIAGNOSTICS)(H4DO) > Electrical Component LocationLOCATION1. CONTROL MODULE(1)Engine control module (ECM)(3)Malfunction indicator light(4)Data link connector(2)Delivery (test) mode fuse 2. SENSOR(1)Mass air flow and intake air temperature sensor(5)Crankshaft position sensor(9)Intake ca ...