Subaru Crosstrek Service Manual: Clear memory mode Operation
ENGINE (DIAGNOSTICS)(H4DO) > Clear Memory Mode
OPERATION
1. SUBARU SELECT MONITOR
NOTE:
• Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
• For detailed operation procedures, refer to “Application help”.
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Engine Control System» and then «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
2. GENERAL SCAN TOOL
For clear memory procedures using the general scan tool, refer to “General Scan Tool Instruction Manual”.
NOTE:
Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
Check list for interview Check
ENGINE (DIAGNOSTICS)(H4DO) > Check List for InterviewCHECK1. CHECK LIST NO. 1Check the following item when problem has occurred.NOTE:Use copies of this page for interviewing customers.Customer&rsqu ...
Data link connector Note
ENGINE (DIAGNOSTICS)(H4DO) > Data Link ConnectorNOTEThis connector is used for Subaru Select Monitor.CAUTION:Do not connect any scan tools other than Subaru Select Monitor or general scan tool beca ...
Other materials:
Light control switch
CAUTION
Extended use of vehicle lighting while the engine is not running may
lead to battery discharge in the Subaru Ascent.
Before leaving your Subaru Ascent unattended, ensure that the light control
switch is set to the OFF position. Even though the lights may automatically
turn off ...
Batch save of event record data Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Batch save of Event record dataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» displa ...
Menu screens
Pull the "
/SET" switch to enter the menu
screens when all of the following conditions
are satisfied.
The vehicle has been completely
stopped.
The select lever is in the "P" position.
The menu screen entering screen is
selected.
The "
" information reminder is off.
Th ...
