Subaru Crosstrek Service Manual: Check list for interview Check
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Check List for Interview
CHECK
• Inspect the following items regarding the vehicle’s state.
• Print out this page for interviewing customers.
Blind Spot Detection/Rear Cross Traffic Alert Check List for Interview | Received Year Month Date | ||
Customer’s name | Registration No.
| Initial year of registration Year Month Date | |
Vehicle model
| Frame number
| ||
Interviewer
| Inspector
| Engine type
| Odometer reading
|
Customer specified content • • • | |||
Date when problem occurred | Year Month Date | Frequency of trouble occurrence | Always occurs Sometimes occurs ( times per day, times per month) |
Condition of trouble occurrence (How the trouble occurs) |
| Weather | Fine • Cloudy • Rainy • Snowy • Others ( ) |
Temperature | °C (°F) — °C (°F) | ||
Road conditions |
| Occurrence location |
|
Accessory installation condition |
| ||
Confirmation of trouble condition |
| ||
Diagnostic Trouble Code |
| ||
Basic diagnostic procedure Procedure
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the ...
Clear memory mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle i ...
Other materials:
Dtc p2097 post catalyst fuel trim system too rich bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2097 POST CATALYST FUEL TRIM SYSTEM TOO RICH BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...
Dtc b1805 short in passenger s airbag
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1805 SHORT IN PASSENGER’S AIRBAGDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted.• Airbag module harness circuit (passenger’s sid ...
Removal
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle n ...
