Subaru Crosstrek Service Manual: Inspection
GLASS/WINDOWS/MIRRORS > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and check visually.
2. If the fuse is blown out, replace the fuse.
2. CHECK RELAY
1. Check the resistance between relay terminals.
Terminal No. | Inspection conditions | Specification | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 2
Apply battery voltage between 4 — 3 terminals.
Less than 1 ?
Terminal No. | Inspection conditions | Specification | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 4
Always
Less than 1 ?
1 — 2
Apply battery voltage between 3 — 5 terminals.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard value.
Relay and fuse
...
Location
GLASS/WINDOWS/MIRRORS > Relay and FuseLOCATIONMain fuse boxRear defogger relay(A)Fuse 25 A (rear defogger)(B)Relay & fuse boxFuse 7.5 A (remote control mirror)(C)Fuse 15 A (wiper deicer)(D)Fuse ...
Other materials:
Installation
STARTING/CHARGING SYSTEMS(H4DO) > GeneratorINSTALLATION1. Temporarily install the generator bracket to the engine and tighten the bolts in the numerical order.Tightening torque:36 N·m (3.7 kgf-m, 26.6 ft-lb)2. Install the V-belt tensioner assembly. V-belt > INSTALLATION">3. Tem ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the air flow control dial or switch to check that the link operates normally.3. If it does not operate normally ...
Dtc p0365 camshaft position sensor "b" circuit bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0365 CAMSHAFT POSITION SENSOR "B" CIRCUIT BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine stall• Failure of engine to startCAUTION:After servicing ...
