Subaru Crosstrek Service Manual: Inspection
GLASS/WINDOWS/MIRRORS > Rear Regulator and Motor Assembly
INSPECTION
1. Disconnect the connector of the motor - rear.
2. Check the motor operation when battery voltage is applied between terminals of the motor - rear connector.
• LH side
Terminal No. | Inspection conditions | Standard |
4 (+) — 1 (−) | Apply battery voltage between terminals. | Increase |
1 (+) — 4 (−) | Apply battery voltage between terminals. | Decrease |
• RH side
Terminal No. | Inspection conditions | Standard |
3 (+) — 6 (−) | Apply battery voltage between terminals. | Increase |
6 (+) — 3 (−) | Apply battery voltage between terminals. | Decrease |
3. If it does not operate properly as a result of inspection, replace the regulator and motor assembly - rear.
Removal
GLASS/WINDOWS/MIRRORS > Rear Regulator and Motor AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. ...
Other materials:
Disc brake pad and disc Inspection
PERIODIC MAINTENANCE SERVICES > Disc Brake Pad and DiscINSPECTIONRefer to “BR” section for disc brake pad and disc inspection. Front Brake Pad > INSPECTION"> Rear Brake Pad > INSPECTION"> Front Disc Rotor > INSPECTION"> Rear Disc Rotor > INSPECT ...
Entering the vehicle while it is running via remote start
1. Unlock the vehicle doors using the
keyless access function (if equipped) or
remote keyless entry system. If the vehicle's
doors are unlocked manually using
the key, the vehicle's alarm system will
trigger (if the alarm system is armed prior
to activating the remote engine start
system) and ...
Inspection
FRONT SUSPENSION > Wheel AlignmentINSPECTIONCheck the following items before performing the wheel alignment measurement.• Tire inflation pressure• Uneven wear of RH and LH tires, or difference of sizes• Tire runout• Excessive play and wear of ball joint• Excessive pl ...
