Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Entering the vehicle while it is running via remote start

Subaru Crosstrek Owners Manual / Starting and operating / Remote engine start system (dealer option) / Entering the vehicle while it is running via remote start

1. Unlock the vehicle doors using the keyless access function (if equipped) or remote keyless entry system. If the vehicle's doors are unlocked manually using the key, the vehicle's alarm system will trigger (if the alarm system is armed prior to activating the remote engine start system) and the engine will turn off.

Perform either of the following procedures to disarm the alarm system. Refer to "Alarm system" F2-26.

2. Enter the vehicle.

3. The engine will shut down when any door or the rear gate is opened.

4. Insert the key into the ignition switch and turn to the "START" position to restart the engine.

Entering the vehicle following remote engine start shutdown

An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown.

Pre-heating or pre-cooling the interior of the vehicle

Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the engine, the heater or air conditioning will activate and heat or cool the interior to your setting.

Remote start safety features
For safety and security reasons, the remote engine start system will prevent starting (or stop the engine if running) and sound the horn twice if any of the following conditions is detected. In ad ...

Service mode (models without "keyless access with push-button start system")
In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced. To engage or disengage service mode: ...

Other materials:

Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).NOTE:Use the 12 mm (0.47 in) dia. holes in th ...

Removal
COOLING(H4DO) > Water PumpREMOVAL1. WATER PUMP PULLEY1. Disconnect the ground cable from battery. NOTE">2. Remove the V-belt covers.3. Remove the V-belts. V-belt > REMOVAL">4. Remove the radiator main fan & fan motor assembly. Radiator Main Fan and Fan Motor > REMOVAL ...

Removal
SECURITY AND LOCKS > IG Relay1 (Push Button Start)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery ...

© 2016-2023 Copyright www.sucross.com