Subaru Crosstrek Service Manual: Installation

CAUTION:

• If the evaporator assembly - cooling has been replaced, add an appropriate amount of compressor oil. Compressor Oil > ADJUSTMENT">

• When the evaporator assembly - cooling has been replaced, replace the packing of the expansion valve - cooling with a new one, and then apply compressor oil.

• Make sure that the water seal packing on the cover attachment area is securely attached.

• Replace the O-rings with new parts, and then apply compressor oil.

• After installing the grille assembly - ventilation RH, check that the air vent grille of the grille assembly - ventilation RH is inserted correctly into the air vent duct.

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Install the thermostat - cooling to the specified position. Evaporator Sensor > INSTALLATION">

2. Install each part in the reverse order of removal.

Tightening torque:

Heater and cooling unit: General Description > COMPONENT">

3. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">

Removal

Evaporator sensor

Other materials:

Wiring diagram
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAM(1)Battery(5)Engine control module (ECM)(9)Torque sensor (main & sub)(2)Ignition switch(6)Power steering control module(10)CAN communication(3)STEERING warning light (combination meter)(7)Motor(11)VD ...

Diagnostic procedure for subaru select monitor communication Communication for initializing impossible
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure for Subaru Select Monitor CommunicationCOMMUNICATION FOR INITIALIZING IMPOSSIBLEDiagnosis:Defective harness connectorTrouble symptom:Subaru Select Monitor communication failureCAUTION:Use the check board when measuring the TC ...

Removal
EXTERIOR BODY PANELS > Rear GateREMOVALCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. REAR GATE PANEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REM ...