Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Rear Combination Light Assembly
INSPECTION
1. Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. | Inspection conditions | Specification |
6 (+) — 3 (−) | Apply battery voltage. | Stop light on |
2 (+) — 3 (−) | Tail (small) / side marker light on | |
4 (+) — 3 (−) | Turn signal light on | |
1 (+) — 3 (−) | Back-up light on |
2. Replace the harness and bulb if it is found defective.
Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be care ...
Other materials:
Preparation tool
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18769AA010EXPANDER PULLEYUsed for removing and installing the secondary pulley assembly.18767AA010BEARING REMOVERUsed for removing the ball bearing of transfer cl ...
Light control and wiper control levers/switches
Windshield wiper
Mist
Windshield washer
Rear window wiper and washer switch
Wiper intermittent time control switch
Wiper control lever
Light control switch
Fog light switch
Headlight ON/OFF/AUTO
Headlight flasher High/Low beam
Turn signal lever
...
Dtc c0045 incorrect vdc control module specifications
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0045 INCORRECT VDC CONTROL MODULE SPECIFICATIONSDTC detecting condition:Different control module specificationTrouble symptom:• ABS does not operate.• VDC does not operate.• ...
