Subaru Crosstrek Service Manual: Lighting system
- Auto headlight beam leveler control module
- Auto headlight beam leveler system
- Back-up light bulb
- Back-up light system
- Clearance light and illumination light system
- Clearance/parking light bulb
- Combination switch (light)
- Day time running light system
- Day time running resistor
- Door switch
- Front fog light assembly
- Front fog light bulb
- Front fog light system
- Front side marker light bulb
- Front turn signal light bulb
- General description
- Glove box light
- Hazard switch
- Headlight assembly
- Headlight bulb
- Headlight system
- High-mounted stop light
- Ignition switch illumination
- Interior light system
- License plate light
- Light control sensor
- Luggage room light
- Rear combination light assembly
- Rear height sensor
- Rear side marker light bulb
- Rear turn signal light bulb
- Reflex reflector
- Relay and fuse
- Room light
- Side turn signal light assembly
- Spot map light
- Srf off switch
- Stop light system
- Tail/stop light bulb
- Turn signal light and hazard light system
- Turn signal light hazard light unit
Read diagnostic trouble code (dtc) Operation
LAN SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and sel ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...
Dtc b2a0d airbag signal
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0D AIRBAG SIGNALDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Either the regular signal or collision signal cannot be detected from the airbag CM for at least 30 seconds. ...
Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEWhen communication with the radar sensor is impossibleDetecting condition:• Defective harness connector• Power supply circuit malfunction• Def ...
