LIGHTING SYSTEM > Stop Light System
NOTE
For operation procedures of each component of the stop light system, refer to the respective section.
• Rear combination light assembly: Rear Combination Light Assembly">
• Tail light/stop light bulb: Tail/Stop Light Bulb">
• High-mounted stop light: High-mounted Stop Light">
Wiring diagramUniform tire quality grading standards
This information indicates the relative
performance of passenger car
tires in the area of treadwear,
traction, and temperature resistance.
This is to aid the consumer
in making an informed choice in the
purchase of tires.
Quality grades can be found where
applicable on the tire sidewall ...
Inspection
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATORPreparation tool:Circuit tester1. Check door lock operationCheck the door lo ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...