Subaru Crosstrek Owners Manual: Uniform tire quality grading standards
This information indicates the relative performance of passenger car tires in the area of treadwear, traction, and temperature resistance.
This is to aid the consumer in making an informed choice in the purchase of tires.
Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example:
Treadwear 200 Traction AA Temperature A
The quality grades apply to new pneumatic tires for use on passenger cars. However, they do not apply to deep tread, winter type snow tires, space-saver or temporary use spare tires, tires with nominal rim diameters of 12 inches or less, or to some limited production tires.
All passenger car tires must conform to Federal Safety Requirements in addition to these grades.
Steps for Determining Correct Load Limit
1. Locate the statement "The combined
weight of occupants and
cargo should never exceed XXX
kg or XXX lbs." on your vehicle's
placard.
2. Determine the combined weight
of the driver and passen ...
Treadwear
The treadwear grade is a comparative
rating based on the wear rate of
the tire when tested under controlled
conditions on a specified
government test course.
For example, a tire graded 150
wou ...
Other materials:
Installation
LUBRICATION(H4DO) > Oil Pressure SwitchINSTALLATION1. Apply liquid gasket to the oil pressure switch threads.Liquid gasket:THREE BOND 1324 (Part No. 004403042) or equivalent2. Install the oil pressure switch to the chain cover.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)3. Connect the ...
Dtc p0441 evap system (cpc) incorrect purge flow
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0441 EVAP SYSTEM (CPC) INCORRECT PURGE FLOWDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Improper idlingCAUTION:After servicing or replacing faulty part ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the glove box. Glove Box > REMOVAL">3. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">4 ...
