Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator Assembly
INSPECTION
1. LATCH
Check if the latch operates normally.
If the cable or rod is faulty, replace the latch & actuator assembly - front.
2. LOCK ACTUATOR
Preparation tool:
Circuit tester
1. Check door lock operation
Check the door lock operation when battery voltage is applied between the terminals of actuator.
Terminal No. | Inspection conditions | Specification |
4 (+) — 1 (−) | Apply battery voltage. | LOCK |
1 (+) — 4 (−) | UNLOCK |
2. Check position switch
Check the resistance between actuator terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard |
8 — 7 | LOCK | 1 M? or more |
UNLOCK | Less than 1 ? |
3. Replace the latch & actuator assembly - front if it is found defective.
Removal
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at ...
Other materials:
Location
LIGHTING SYSTEM > Relay and FuseLOCATIONMain fuse boxHeadlight relay (HI)(A)Headlight relay (LO)(B)Fuse 15 A (daytime running light relay)(C)Fuse 30 A (combination light LH/RH)(D)Fuse 20 A (spot map light, room light, ignition switch illumination (immobilizer antenna))(E)Fuse 15 A (tail and illum ...
Brake system warning light
In the Subaru Ascent, the brake system warning light illuminates when the parking
brake is engaged while the ignition switch is in the "ON" position. This is a normal
operational indication. Once the parking brake is fully released, the light should
turn off immediately, confirming t ...
Installation
SECURITY AND LOCKS > Remote OpenersINSTALLATION1. Before installation, check the following items.• Cable is free from deformation such as fray.2. Install each part in the reverse order of removal.Tightening torque:Front hood lock: General Description > COMPONENT">Remote opener: ...
