Subaru Crosstrek Service Manual: Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft Assembly
REMOVAL
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">
2. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">
3. Remove the transmission case. Transmission Case > REMOVAL">
4. Remove the drive pinion shaft assembly. Drive Pinion Shaft Assembly > REMOVAL">
5. Remove the main shaft assembly.
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, an ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyASSEMBLY1. When the sleeve & hub assemblies have been disassembled, reassemble by aligning the alignment marks.NOTE:Position the o ...
Other materials:
Dtc p0971 pressure control solenoid "c" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0971 PRESSURE CONTROL SOLENOID "C" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Tight corner braking phenomenon occurs.&b ...
Removal
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle n ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the air flow control dial or switch to check that the link operates normally.3. If it does not operate normally ...
