Subaru Crosstrek Service Manual: Adjustment

Subaru Crosstrek Service Manual / Manual transmission and differential(5mt) / Main shaft assembly / Adjustment

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft Assembly

ADJUSTMENT

Selection of main shaft rear plate:

Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.

NOTE:

Before measuring, tap the end of main shaft with a plastic hammer lightly in order to make the clearance zero between the main case surface and moving flange of bearing.

Dimension (A) mm (in)	Part No.	Mark
4.00 — 4.13 (0.1575 — 0.1626)	32294AA041	1
3.87 — 4.00 (0.1524 — 0.1575)	32294AA051	2

Dimension (A)

mm (in)

Part No.

Mark

4.00 — 4.13

(0.1575 — 0.1626)

32294AA041

3.87 — 4.00

(0.1524 — 0.1575)

32294AA051

Removal

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the ...

Other materials:

Dtc p0021 "a" camshaft position - timing over-advanced or system performance bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0021 "A" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine sta ...

Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyADJUSTMENT1. Using the ST, screw-in the retainer until resistance is felt.NOTE:RH side should be screwed-in more than LH side.ST 18658AA020WRENCH COMPL RETAINER2. Remove the remaining liquid gasket from the mating surface c ...

Removal
EXTERIOR/INTERIOR TRIM > Glove BoxREMOVALNOTE:Refer to “Security and Locks” section for key cylinder replacement. Key Lock Cylinders > REPLACEMENT">1. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remove the damper COMPL - pocket ...