Subaru Crosstrek Service Manual: Manual transmission and differential(5mt)
- Air breather hose
- Center differential
- Differential side retainer oil seal
- Drive pinion shaft assembly
- Front differential assembly
- General description
- Main shaft assembly
- Manual transmission assembly
- Oil seal
- Reverse check sleeve
- Reverse idler gear
- Shifter fork and rod
- Switches and harness
- Transfer case and extension case assembly
- Transfer drive gear
- Transfer driven gear
- Transmission case
- Transmission gear oil
- Transmission mounting system
- General diagnostic table Inspection
- Preparation for overhaul Procedure
Oil pump Specification
LUBRICATION(H4DO) > Oil PumpSPECIFICATIONThe oil pump cannot be disassembled.Refer to “Chain Cover” for removal and installation procedures. Chain Cover > REMOVAL"> Chain C ...
Other materials:
Engine
SPECIFICATIONS > CrosstrekENGINEModel2.0 L DOHC non-turboEngine typeHorizontally opposed, liquid cooled, 4-cylinder, 4-stroke gasoline engineValve arrangementDOHCBore ? strokemm (in)84.0 ? 90.0 (3.31 ? 3.54)Displacementcm3 (cu in)1,995 (121.7)Compression ratio10.5Ignition order1 — 3 — 2 — 4 ...
Inspection
SECURITY AND LOCKS > Push Button Start SystemINSPECTION1. POWER SUPPLY SWITCH FUNCTION INSPECTION1. Check push button ignition switch function(1) Check the change control through push button ignition switch, brake pedal operation, and shift position.Shift lever positionBrake pedal operationPush b ...
Removal
DRIVE SHAFT SYSTEM > Front Drive ShaftREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle nut ...
