InspectionDaylight saving time setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
"
switch to
select the "Daylight Saving Time" item.
Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection ...
System block diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAM• Blind Spot Detection/Rear Cross Traffic Alert system consists of the following.• There is a control ECM in the radar sensor main body, which performs the vehicle identification ...
Removal
WIPER AND WASHER SYSTEMS > Combination Switch (Wiper)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Release the clips, and remove the cover assembly - steering UPR.(2) Remove the screws by turning the steering wheel to right and left.( ...