Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve
INSTALLATION
1. Install the reverse check sleeve.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
2. Install the reverse check ball, reverse accent spring, gasket and plug.
NOTE:
Use a new gasket.
Tightening torque:
9.75 N·m (1.0 kgf-m, 7.2 ft-lb)
3. Install the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION">
4. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION">
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveINSPECTION• Make sure the cutout of the reverse accent shaft is aligned with the opening in the reverse check sleeve.• Tu ...
Other materials:
Disassembly
BRAKE > Master CylinderDISASSEMBLY1. Remove the reservoir tank.CAUTION:Be careful not to tighten a vise excessively.(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.(2) Drive out the pin using a punch and a hammer to remove the reservoir tank.2. Remove the seal ...
Assembly
BRAKE > Front Disc Brake AssemblyASSEMBLY1. Before assembly, check each part. Front Disc Brake Assembly > INSPECTION">2. Clean the inside of the caliper body cylinder using brake fluid.3. Apply a coat of brake fluid to piston seal and install the piston seal to the caliper body cylind ...
Dtc p0616 starter relay "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0616 STARTER RELAY "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATI ...
