Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve

INSPECTION

Make sure the cutout of the reverse accent shaft is aligned with the opening in the reverse check sleeve.

Turn the cam by hand to check for smooth rotation.

Move the cam and shaft all the way toward the plate, and make sure it releases.

If the cam does not return properly, replace the reverse check spring. If the shaft does not return, check for scratches on the inner surface of sleeve. If the sleeve is in good order, replace the spring.

(A)

Snap ring

(B)

Reverse check plate

(C)

Reverse check spring

(D)

Reverse check cam

Select a suitable reverse accent shaft and reverse check plate. Reverse Check Sleeve > ADJUSTMENT">

Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveDISASSEMBLY1. Cover the reverse check sleeve with cloth, and remove the snap ring by using screwdriver.NOTE:If the snap ring is defor ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveINSTALLATION1. Install the reverse check sleeve.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the reverse check b ...

Other materials:

Removal
CLUTCH SYSTEM > Operating CylinderREMOVALCAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp ...

Cruise control (if equipped)
NOTE For models with EyeSight system: Refer to the Owner's Manual supplement for the EyeSight system. Cruise control enables you to maintain a constant vehicle speed without holding your foot on the accelerator pedal and it is operative when the vehicle speed is 25 mph (40 km/h) or more. WA ...

Read diagnostic trouble code (dtc) Operation
LAN SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «All diagnosis code».NOTE:• For detail ...

© 2016-2025 Copyright www.sucross.com