Subaru Crosstrek Service Manual: Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve
DISASSEMBLY
1. Cover the reverse check sleeve with cloth, and remove the snap ring by using screwdriver.
NOTE:
If the snap ring is deformed or the spring repulsive force is not enough, replace with a new snap ring.
(A) | Snap ring |
2. Remove the reverse check plate, reverse check spring, reverse check cam, return spring (5th-Reverse), reverse accent shaft, return spring cap, and return spring (1st-2nd).
(A) | Reverse check plate |
(B) | Reverse check spring |
(C) | Return spring (5th-Reverse) |
(D) | Reverse check cam |
(E) | Reverse accent shaft |
(F) | Return spring cap |
(G) | Return spring (1st-2nd) |
3. Remove the O-ring.
NOTE:
Be careful not to damage the adjusting shim between reverse check sleeve assembly and case.
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveASSEMBLY1. Install the return spring (1st-2nd), return spring cap, reverse accent shaft, reverse check cam, return spring (5th-Revers ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveINSPECTION• Make sure the cutout of the reverse accent shaft is aligned with the opening in the reverse check sleeve.• Tu ...
Other materials:
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Ambient SensorREMOVAL1. Disconnect the ground cable from battery. Battery > REMOVAL">2. Remove the ambient sensor.(1) Disconnect the connector.(2) Release the claws, and then remove the ambient sensor from the bracket. ...
Removal
INSTRUMENTATION/DRIVER INFO > Steering SwitchREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Set the tire to the straight-ahead position.2 ...
Assembly
DRIVE SHAFT SYSTEM > Front Drive ShaftASSEMBLY1. Roll up a thick piece of paper to a size where the shaft can pass through, and affix with tape to form a cylinder.2. Attach a new O-ring on this cylinder.CAUTION:• Always use a new O-ring.• Be careful that the O-ring does not become scr ...
